產品詳情商家聯系電話：86-0755-83996702
RA55H3340M是55-watt RF的MOSFET放大器模塊12.5-volt移動電臺在向工作在330-400-MHz范圍.電池可以直接連接到漏極增強型MOSFET晶體管.如果沒有門電壓(VGG進入=0V),只有一小漏電流漏極和RF衰減輸入信號的最高60 dB.輸出功率和漏電流增加門極電壓增加.與周圍4V柵極電壓（最小），輸出功率和漏電流大幅增加.標稱輸出功率變在4.5V（典型值），5V可用（最大）.在VGG=5V,的典型柵極電流1 mA.該模塊是專為非線性調頻調制，但也可能是線性調制使用設置排水靜態電流與柵極電壓和控制輸出功率與輸入功率.
特征
•增強型MOSFET晶體管(IDD≅0@ VDD=12.5V, VGG=0V)
• Pout>55W,ηT>35% @ VDD=12.5V, VGG=5V, Pin=50mW
•寬帶頻率范圍：330-400MHz
•低功耗控制電流IGG=1mA (typ)在VGG=5V
•模塊尺寸：66 x 21 x 9.88 mm
•線性操作有可能通過設置靜態漏電流隨柵極電壓和輸出功率控制與輸入功率.
RA55H3340M： Silicon RF Power Modules RoHS Compliance , 330-400MHz 55W 12.5V, 3 Stage Amp. For MOBILE RADIO
DESCRIPTION
The RA55H3340M is a 55-watt RF MOSFET Amplifier Module for 12.5-volt mobile radios that operate in the 330- to 400-MHz range.The battery can be connected directly to the drain of the
enhancement-mode MOSFET transistors. Without the gate voltage (VGG=0V), only a small leakage current flows into the drain and the RF input signal attenuates up to 60 dB. The output power and drain current increase as the gate voltage increases. With a gate voltage around 4V (minimum), output power and drain current increases substantially.The nominal output power becomes available at 4.5V (typical) and 5V(maximum). At VGG=5V, the typical gate current is 1 mA.This module is designed for non-linear FM modulation, but may also be used for linear modulation by setting the drain quiescent current with the gate voltage and controlling the output power with the input power.
FEATURES
• Enhancement- Mode MOSFET Transistors (IDD≅0 @ VDD=12.5V, VGG=0V)
• Pout>55W, ηT>35% @ VDD=12.5V, VGG=5V, Pin=50mW
• Broadband Frequency Range: 330-400MHz
• Low-Power Control Current IGG=1mA (typ) at VGG=5V
• Module Size: 66 x 21 x 9.88 mm
• Linear operation is possible by setting the quiescent drain current with the gate voltage and controlling the output power with the input power RoHS COMPLIANCE
• RA55H3340M-101 is a RoHS compliant products.
• RoHS compliance is indicate by the letter “G” after the Lot Marking.
• This product include the lead in the Glass of electronic parts and the lead in electronic Ceramic parts.However, it is applicable to the following exceptions of RoHS Directions.
1.Lead in the Glass of a cathode-ray tube, electronic parts, and fluorescent tubes.
2.Lead in electronic Ceramic parts.
ORDERING INFORMATION:
ORDER NUMBER： RA55H3340M-101
SUPPLY FORM： Antistatic tray,10 modules/tray
